#Ip camera wireless password#

The default username and password are ubnt and click on the check box on the bottom of the page before pressing login.Īfter you login for the first time you will be prompted to change the default password.

The login page should look like the one below. We are using Chrome as the browser in this case. If you do not see the login page, and get a security error message, follow the instructions provided in the image below. Be sure you are using a compatible network, and enter this ip address in to the address bar of your web browser.

The default ip address of Ubiquiti radios is 192.168.1.20. Here is a close-up view of the PoE injector: Connect the AP to the power injector using the MAIN (PoE) port, and the power injector to your switch or router using the SECONDARY (LAN) port as pictured below. Each access point comes with a PoE injector. To configure the AP you need to first connect it to your network so you can access it's internal web-based settings page. We prefer using Ubiquiti access points as they are inexpensive and reliable. This setup guide is for situations where you would like to access the camera with your laptop over WiFi. The main purpose of the access point is to take the network traffic from your IP camera and make it wireless while acting as a transparent bridge between your laptop WiFi radio and the camera. Setup your access point with an IP address compatible with your IP camera. Otherwise the address will change every time the camera or router power cycles. Make sure your IP address for the camera is set to static.